The cutting bed on our Travelling Head Press Cutting Machine is 500mm x 2M allowing us to produce individual cut parts up to this size.

Virtually any flexible material (typically Self Adhesive Foam, Non Adhesive Foam, Cork, Fabric, Plastic and Gasket Materials) up-to 50mm thick can be supplied as finished components.

Inexpensive Dies are used to cut shapes to Customer exact requirements with or without an adhesive backing. The Travelling Head Press Cutting Machine uses pressure to push the Die through the required material leaving a perfectly cut individual piece of finished material.

A very typical example of what can be achieved on this machine would be to feed in a roll of 1M wide x 6mm thick x 10M Closed Cell Expanded Neoprene Foam with an Acrylic Adhesive on one face. A tool in the shape of a rectangle 300mm x 300mm with 4 holes, each 25mm in Diameter is used to cut through the material. The end result is individual gaskets 300mm x 300mm with 4 perfectly located 25mm Diameter holes in 6mm thick Closed Cell Expanded Neoprene Foam ready for the Customer to apply.

Normal materials processed using the Travelling Head Press Cutting Machine are: -

• Non Adhesive Neoprene Foam
• Self Adhesive Neoprene Foam
• Non Adhesive EPDM Foam
• Self Adhesive EPDM Foam
• Non Adhesive Polyurethane Foam (Non Adhesive PU Foam)
• Self Adhesive Polyurethane Foam (Self Adhesive PU Foam)
• Non Adhesive Polyethylene Foam (Non Adhesive PE Foam)
• Self Adhesive Polyethylene Foam (Self Adhesive PE Foam)
• Cork bonded with adhesive and cork boded with rubber such as nitrile.

We can produce one component upwards and Lead Times are very short with Travelling Head Press Cut Components.

Register Here to receive a 10% Discount on your first order with Lynvale for Travelling Head Press Cut Components.